Toshiba e-STUDIO 163 - Page 26

e-STUDIO163/203 ERROR CODE AND SELF-DIAGNOSTIC MODE December 2005 © TOSHIBA TEC
2 - 8
2.2.2 Output check (Test mode 04)
<Operation procedure>
Procedure 1
Procedure 2
Procedure 3
Status of the output signals can be checked by keying in the following codes in the test mode 04.
[0][4]
[POWER]
[Digital keys]
Code
[START]
[START]
Operation
ON
[Digital keys]
Stop code
[POWER]
OFF/ON
Operation
OFF
[0][4]
[POWER]
[Digital keys]
Code
[START]
[POWER]
OFF/ON
[0][4]
[POWER]
[Digital keys]
Code
[START] [CLEAR]
[FUNCTION
CLEAR]
[POWER]
OFF/ON
Operation
OFF
Operation
ON