5 APPENDIX
36 Default Setting List
Default Setting List
The printing-related default settings of this equipment are shown below.
The default setting values are the ones set at the factory when this equipment is shipped.
You can see the current setting values by printing the "Configuration Page" from the opera-
tion panel of this equipment. See the following page for how to print the "Configuration
Page".
Setup Guide for Printing Functions
Chapter 4 "PRINTING LISTS (EQUIPMENT)"
To Print List
"Configuration page"
Default settings for network setting
General
Link Speed/Duplex Mode ........................................... Auto
TCP/IP
Address Mode............................................................. Dynamic
IP Address .................................................................. Undefined
Subnet Mask ............................................................... Undefined
Default Gateway ......................................................... Undefined
IPX/SPX
Enable IPX/SPX.......................................................... Enable
Frame Type................................................................. Auto Sense
AppleTalk
Enable AppleTalk ........................................................ Enable
Device Name ..............................................................MFP_[NIC Serial Number]
Desired Zone ..............................................................*
DNS session
Enable DNS ................................................................ Enable
Primary DNS Server Address ..................................... 0.0.0.0
Secondary DNS Server Address ................................0.0.0.0
DDNS session
Enable DDNS.............................................................. Enable
Host Name .................................................................. MFP-[NIC Serial Number]
Domain Name ............................................................. Undefined
To Next Page
Loading...
