3 PRINT FUNCTIONS
72 Setting Up Print Options
4) Paper Source
Selects a paper source to print a job in the most suitable paper size. The figure on the right indicates the paper size set
for each paper source. When you select a paper source, the chosen one is indicated with a green square in the figure.
- Auto
— Automatically selects the paper set in this equipment according to the printed document size.
- Drawer 1 — Paper is fed from the Drawer 1.
- Drawer 2 — Paper is fed from the Drawer 2.
- Bypass Tray — Paper is fed from the Bypass Tray.
The selectable values vary depending on the devices installed in this equipment and their configuration on the
[Configuration] tab.
5) Paper Type
Sets the media type of the paper.
- Plain — Printing on plain paper.
- Thick1 — Printing on thick 1 paper.
- Thick2 — Printing on thick 2 paper.
- Transparency — Printing on transparent sheets.
- Thin — Printing on the back side of thin paper.
The applicable paper weight for each paper type differs depending on the model. For details of the paper
weight, refer to the corresponding document.
When [Drawer 1] or [Drawer 2] is selected in the [Paper Source] box, only [Plain] can be chosen in the [Paper
Type] box.
When [Envelope] is selected in the [Print Paper Size] box, [Envelope] will be displayed and you cannot change
the paper type.
Setup items differ depending on the model.
6) Number of Copies
Sets the number of printed copies. This can be set at between 1 and 999.
7) Orientation
Sets the paper printing direction.
- Portrait
— The document is printed in the portrait direction.
- Landscape — The document is printed in the landscape direction.
To Next Page
Loading...
