e-STUDIO200L/202L/230/232/280/282 SCANNER June 2004 © TOSHIBA TEC
6 - 24
[G] Mirror-1
(6) Rotate the carriage-1 in the direction shown
in the figure at right, not to touch the mirror.
Then take out the carriage-1.
Fig. 6-38
Notes:
1. When installing the carriage-1, fix the
bracket temporarily at the position (A).
Then move it to the direction (B) slowly,
push it to the end of frame and fix at this
position with the screws.
2. Refer to the “3.7.1 Carriages” in the Ser-
vice Handbook
3. Rotate the drive pulley to move the car-
riage.
Fig. 6-39
(1) Take off the carriage-1
(! P.6-22 "[F] Carriage-1").
Note:
When replacing the mirror-1, replace it
together with the carriage-1. The mirror-1
should not be removed separately.
Carriage-1
(
B
)
(
A
)
(
A
)
Bracket
Bracket
To Next Page
Loading...
