6
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 SCANNER
6 - 25
[H] Inverter board
[I] Carriage wire / Carriage-2
(1) Take off the carriage-1
(! P.6-22 "[F] Carriage-1").
(2) Disconnect 2 connectors.
(3) Remove 2 screws and take off the inverter
board.
Fig. 6-40
(1) Take off the carriage-1
(! P.6-22 "[F] Carriage-1").
(2) Install the wire holder jig to each pulley on
front and rear sides, not to loosen the car-
riage wire.
Note:
Refer to “3.7.1 Carriages” in the Service
Handbook for the installation direction of the
wire holder jig.
Fig. 6-41
(3) Remove the tension springs on both front
and rear sides.
(4) Remove the carriage wires on both front and
rear sides.
Fig. 6-42
Inverter board
Wire holder jig
Tension spring
Carriage wire
Carriage wire
Tension spring
To Next Page
Loading...
