e-STUDIO200L/202L/230/232/280/282 SCANNER June 2004 © TOSHIBA TEC
6 - 26
[J] Mirrors-2 and -3
[K] Platen sensor
(5) Rotate the carriage-2 in the direction where
the inside of the frame is dented shown in
the figure at right, not to touch the mirror.
Then take off the carriage-2.
Fig. 6-43
(1) Take off the carriage-2
(! P.6-25 "[I] Carriage wire / Carriage-2").
Note:
When replacing the mirrors-2 and -3, replace
them together with the carriage-2. The mir-
rors-2 and –3 should not be removed sepa-
rately.
(1) Take off the rear cover an upper rear cover
(! P.2-31 "[C] Rear cover", ! P.2-34 "[I]
Upper rear cover").
(2) Disconnect 1 connector from the platen sen-
sor on the left rear position of the equipment
upper side.
(3) Release the latches of the sensor and take
off the platen sensor.
Fig. 6-44
Carriage-2
Platen sensor
To Next Page
Loading...
