e-STUDIO200L/202L/230/232/280/282 PAPER FEEDING SYSTEM June 2004 © TOSHIBA TEC
9 - 16
[E] Bypass paper sensor
(4) Remove 1 clip and take off the bypass feed
roller unit from the shaft. Then take off the
bypass feed roller.
Fig.9-17
(1) Take off the bypass feed unit
(! P.9-13 "[B] Bypass feed unit").
(2) Remove 2 screws and take off the upper
guide.
Fig.9-18
(3) Release the latches and take off the bypass
paper sensor.
Fig.9-19
Bypass feed roller
Bypass feed roller unit
Clip
Upper guide
Bypass paper sensor
To Next Page
Loading...
