9
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 PAPER FEEDING SYSTEM
9 - 17
[F] Bypass feed clutch
[G] Bypass unit
(1) Take off the bypass feed unit
(! P.9-13 "[B] Bypass feed unit").
(2) Remove 1 clip. Take off the bypass feed
clutch together with the bushing and bracket.
Fig.9-20
(1) If the ADU is not installed, take off the right
front hinge cover, the right rear hinge cover
and the bypass upper cover
(! P.2-38 "[P] Right front hinge cover", !
P.2-39 "[Q] Right rear hinge cover", ! P.2-
39 "[R] Bypass upper cover").
If the ADU is installed, take off the ADU
(! P.15-10 "[A] Automatic Duplexing Unit
(ADU)").
(2) Open the side cover.
(3) Disconnect 2 connectors. Remove 5 screws
and take off the bypass unit.
Note:
Make sure to let the disconnected connector
(A) (harness) through the hole (B).
Fig.9-21
Bracket
Bypass feed clutch
Bushing
Clip
Bypass unit
A
B
04/09
To Next Page
Loading...
