11
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 DRUM RELATED SECTION
11 - 9
[B] Drum cleaner unit
(1) Take out the process unit
(! P.11-8 "[A] Process unit").
(2) Disconnect 2 connectors and remove 2
screws.
(3) Release 1 latch. Then pull out the process
unit front cover and take it off.
Note:
When installing the process unit front cover,
wire the harness correctly in order not to con-
tact the gears and harness of the process
unit front cover each other.
Fig.11-7
Fig.11-8
Process unit front cover Connector
Connector
Latch
Process unit
front cover
Harness
To Next Page
Loading...
