2
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
OUTLINE OF THE MACHINE
2 - 25
[D] Switching regulator unit (PS)
(3) Disconnect 2 connectors, remove 1 screw,
and then take off the fuse PC board by lifting
it up.
Fig. 2-28
Note:
When the fuse PC board is installed as
options, remove the rear cover (" P.2-22
"[J] Rear cover") and disconnect connec-
tors before performing the procedure
below.
Fig. 2-29
Connector
Fuse PC board
Connector
To Next Page
Loading...
