e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 26
(1) Take off the left cover.
" P.2-19 "[C] Left cover"
(2) Disconnect 13 connectors.
Note:
Connect the connectors to the correct faston
terminals on the switching regulator board.
Connector Harness
F. Red - Black-thick
E. Blue - White-thick
D. White - Black-thin
C. White - Red-thin
B. White - Red-thick
A. White - White-thick
Fig. 2-30
Fig. 2-31
(3) Remove 2 screws, slide the switching regula-
tor unit with the whole case slightly to the
front, and then lift it up to take it off.
Fig. 2-32
F
E
D
C
B
A
Switching regulator unit
To Next Page
Loading...
