13
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO167/207/237
FUSER / EXIT UNIT
13 - 21
[J] Fuser thermostat (THMO1)
[K] Exit motor (M7): Option
Note:
When installing the thermistors, do not mix
up the installation positions of the side ther-
mistor and the edge thermistor by telling
them apart by the length of their harnesses.
Fig. 13-32
(1) Take off the fuser roller.
P.13-18 "[G] Fuser roller"
(2) Remove 2 screws and take off the fuser ther-
mostat.
Fig. 13-33
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Disconnect 1 connector, remove 1 screw,
and then take off the exit motor with the
bracket while sliding it toward the right.
Fig. 13-34
Center thermistor
Side thermistor
Edge thermistor
Fuser thermostat
ConnectorBracket
Exit motor Screw
To Next Page
Loading...
