13
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 FUSER UNIT
13 - 13
[D] Heater lamp
(1) Take off the fuser unit upper cover
(! P.13-12 "[B] Fuser unit upper cover").
(2) Remove 2 springs.
Note:
When installing the spring, catch the spring
on the lower hook.
Fig.13-11
(3) Remove 4 screws and take off the separation
finger bracket.
Fig.13-12
(4) Remove 2 screws of each the center heater
lamp and the side heater lamp.
Fig.13-13
Spring
Separation finger bracket
To Next Page
Loading...
