e-STUDIO200L/202L/230/232/280/282 OUTLINE OF THE MACHINE June 2004 © TOSHIBA TEC
2 - 44
[B] NIC board (GF-1150)
e-STUDIO200L/230/230L/280/280S only
(6) Remove 4 screws and take off the HDD from
the bracket. Disconnect 2 connectors.
Remove 1 screw and take off the ground
wire.
Fig. 2-52
(7) Disconnect 1 connector. Remove 2 screws
and take off the HDD cooling fan from the
SYS board cover.
Fig. 2-53
(1) Take off the SYS board lower cover and SYS
board upper cover
(! P.2-41 "[A] Hard disk (HDD)").
(2) Release 2 locking supports, remove 2
screws, and then take off the NIC board.
Note:
NIC board is available as an option (GF-
1150) for some destinations or versions.
Fig. 2-54
HDD
Ground wire
HDD cooling fan
NIC board
05/11
To Next Page
Loading...
