5 Printing from Windows
194 Before Using the Printer Driver
2
Display the [Configuration] tab, check off the “Enable SNMP Com-
munication” option, and set the following options.
Drawer — This sets whether the drawers or LCF (not available for some countries or
regions) are installed.
Automatic Duplexing Unit — This sets whether or not optional automatic duplexing unit
is installed. (For e-STUDIO282 Series Only)
Finisher — This sets whether or not optional finisher is installed.
Hole Punch Unit — This sets whether or not optional hole punch unit is installed.
Drawer 1/Paper Type — Select the paper size and paper type of paper that is loaded in
the 1st Drawer.
Drawer 2/Paper Type — Select the paper size and paper type of paper that is loaded in
the 2nd Drawer.
Drawer 3/Paper Type — Select the paper size and paper type of paper that is loaded in
the 3rd Drawer when it is installed.
Drawer 4/Paper Type — Select the paper size and paper type of paper that is loaded in
the 4th Drawer when it is installed.
LCF/Paper Type — Select the paper size and paper type of paper that is loaded in the
LCF when it is installed.
Bypass Tray — Select the paper type of paper that is loaded in the Bypass Tray.
Memory — Select the size of memory.
LCF is not available for some countries or regions.
For more information about each item, see descriptions about the Configuration Tab.
P.234 “Configuration Tab”
3
Check the “Override Application Paper Settings” option if you want
to use the paper source setting in the printer driver rather than the
application setting.
4
Click [Apply] and [OK] to save settings.
To Next Page
Loading...
