131
5
4
Press the [LEFT] (or [RIGHT]) button.
5
Adjust the margin width by pressing the [2 mm] or [100 mm] button,
and then press the [ENTER] button.
• The default width of the margin is 7 mm.
• In duplex copying, margins on the back are created on the other side of those in the front. ( P.112 “4.Duplex
Copying”)
• If the ‘Top or Bottom margin’ has already been set, the value of the margin width is replaced by the one set in
this step.
6
Press the [ENTER] button.
• Select other copy modes as required.
7
Press the [START] button.
To Next Page
Loading...
