Toshiba e-studio 250 - CCD Unit

December 2002 TOSHIBA TEC 7 - 29 e-STUDIO160/200/250 SCANNER
Fig. 7-8-33
CCD unit
Flat cable
Connector
Screw
065-10
[J] CCD unit
1. If an Original Cover (KA-1600PC), ADF
(MR-2012), or the RADF (MR-3011) is attached
to the copier, open it.
2. Remove original glass. (See Fig. 7-8-7)
3. Remove the blind plate.
(See Fig. 7-8-16 and 7-8-17)
4. Remove 3 screws, detach 2 connectors, and
remove CCD unit.
Notes: 1. When attaching the flexible cable, se-
curely lock the connector locks on both
sides of the connector.
2. For mounting the CCD unit and adjust-
ing the enlargement/reduction of images,
refer to the Service Handbook.
(See Chapter 1.8)
[K] Document size sensor (DP2000/2500 series)
1. If an Original Cover (KA-1600PC), ADF
(MR-2012), or the RADF (MR-3011) is attached
to the copier, open it.
2. Remove original glass. (See Fig. 7-8-7)
3. Remove the blind plate.
(See Fig. 7-8-16 and 7-8-17)
4. Remove 5 screws, detach 5 connectors, and
remove document size sensor.
Note: When installing document size sensor, the
harness must not obstruct CCD.
Fig. 7-8-34
Fig. 7-8-35
065-5-5
Document
size sensor
065-5-4
Screw
Document
size sensor
Connector
NAD model MJD/SAD/AUD/CND
models