Toshiba e-studio 250 - Page 59

December 2002 TOSHIBA TEC 3 - 11 e-STUDIO160/200/250 COPYING PROCESS
4. Detach the main charger assembly.
Note: Be sure not to touch the grid part of the main
charger grid.
Fig. 3-4-4
1
2
3-4-04
5. Release 4 hooks and detach the main charger
grid.
Main charger
assembly
Fig. 3-4-5
6. Pull out the main charger wire bracket and re-
move the main charger wire located in front side
from the spring.
7. Remove the main charger wire located in rear
side from the hook.
Fig. 3-4-6
Fig. 3-4-7
Main charger grid
Hook
Hook
3-4-05
Main charger wire
Main charger wire
bracket
Spring
Hook
3-4-06
Main charger wire
cleaning pad
Main charger wire
cleaning pad
Main charger wire
3-4-07
Notes: 1. Be sure to attach the main charger wire
through the space between the main
charger cleaning pads. (See Fig. 3-4-7.)
2. Do not touch the main charger wire with
your fingers.
3. Clean the inside of the main charger as-
sembly if toner is stuck.