3. Printing
274 Printing Guide — Printing from Macintosh
— Booklet Mode Options
In the Booklet Mode Options menu, you can set booklet printing.
1) Booklet Page Size
Select a paper size to print a booklet. Each two pages are printed on both side of a
sheet before folding. The booklet size will be the half size of the paper size you
specify here.
NOTE: When booklet is used with cover page, it is recommended to use AppleTalk printing
rather than LPR printing.
2) Booklet Page Layout
Select the direction to be printed.
- Right to Left — Select this to create a booklet can be read from right to left.
- Left to Right — Select this to create a booklet can be read from left to right.
3) Booklet Center Margin
Select the width of space added to the center. If there is not a preferred width in the
list, enter the width by points. You can enter from 0 point to 300 points in units of 1
point.
4) Booklet Outer Margin
Select the width of space added in the short-edge side on a sheet. If there is not a
preferred width in the list, enter the width by points. You can enter from 0 point to 18
points in units of 1 point.
1
2
3
4
To Next Page
Loading...
