Scanning Remotely Using Remote Scan Driver 125
2
When the process is completed, found devices are listed in the list.
If the process continues for a long time, it is because too many network clients are on the
network. In that case, you can configure the discovery using the [Advanced] button.
P.126 “Configuring Discovery Settings”
3
Select the equipment that you want to connect from the list and
click [OK].
y You are connected to the selected device.
Discovering the device manually
1
In the TopAccessDocMon Local Discovery dialog box, click [Manual
Selection].
y The Manual Selection dialog box appears.
To Next Page
Loading...
