Toshiba e-studio 2822AF - e-STUDIO Left Side Components

1.PREPARATION
Components 11
PREPARATION
 Left side
1. Original glass
Place the book-type originals and special paper such as overhead transparencies or tracing paper, as well as
plain paper.
2. Control panel
Make settings to use the various functions on this equipment.
 P.13 “Control panel”
3. Receiving tray
4. Paper exit stopper
Stops large paper from sliding out of the receiving tray.
When you use the stopper, pull it out and unfold the wire portion.
5. Power switch
Turns the power ON or OFF.
 P.17 “Preparation 1 - Turning Power ON”
6. AC-IN terminal (rear)
Connect the power cable supplied with the equipment.
7. TEL (Only for e-STUDIO2822AF)
Connect to an external telephone.
For details on how to use the Fax functions, see the following manual.
Fax Guide
8. Network interface connector
Use this connector when connecting this equipment to a network.
8
9
3
11
13
6
5
1
2
4
12
7
10