- 59 -
Scanning to E-mail
4
Scanning
Step 2-3 Conguring Your
Machine’s E-mail Settings
Set up your machine’s e-mail settings using the
information in the Setup Information Form.
1 Press the <SETTING> key on the
operator panel.
2 Press the to select [Easy Setup] and
press
OK
.
3 Enter the administrator password.
The factory default password is “aaaaaa”.
a Press , , , to select the
character you want, and then
press
OK
.
- The selected character is entered as “*” in
the text eld.
- If you have entered an incorrect value,
press the <CLEAR> key and then enter
the correct value.
b Repeat step a until all characters
required are entered.
c Press the and to select [Enter]
and press
OK
.
4 Press the to select [E-mail Setting]
and then press the .
5 Press the and then enter the
information in B-2.
6 Select [Enter] and then press
OK
.
7 Press the and then enter the
information in B-1.
8 Select [Enter] and then press
OK
.
9 Press the and then select a protocol
for receiving e-mail for the machine, and
then press
OK
.
- If you want your machine to receive
e-mail from the POP3 server, select
[POP3]. Proceed to step 10.
- If you want your machine to receive
e-mail without using a mail server, select
[SMTP]. Proceed to step 12.
- If you do not want your machine to
receive e-mail, select [Disable]. Proceed
to step 12.
10 Press the and then enter the
information in B-3.
11 Select [Enter] and then press
OK
.
To Next Page
Loading...
