Toshiba e-Studio 332s - Other Operations; Initializing Network Settings; Using DHCP

Other Operations
-159-
Network Settings
8
 Other Operations
This section explains how to initialize the network settings and how to setup your machine and computer
to use DHCP.
Initializing Network Settings
Note
z This procedure initializes all the network settings.
1 Press the <SETTING> key.
2 Press to select [Admin Setup] and
then press .
3 Enter the administrator password.
4 Select [Enter] and then press .
5 Press to select [Network Menu] and
then press .
6 Check that [Network Setup] is selected
and then press .
7 Press to select [Factory Defaults]
and then press .
8 Check that [Execute] is selected and
then press .
9 On the confirmation screen, press or
to select [Yes] and then press .
The network card reboots to initialize the settings.
Using DHCP
You can obtain an IP address from the DHCP
server.
Note
z You must be authorized as the administrator.
z The network system may go down if you enter an incorrect
IP address.
Memo
z You can obtain an IP address from the BOOTP server.
Configuring DHCP Server
DHCP assigns an IP address to each host on the
TCP/IP network.
Note
z The machine must have a static IP address if you want to
print via a network. For details on how to assign a static IP
address, refer to the manual of your DHCP server.
Memo
z The following OSes are supported:
- Windows Server 2008 R2, Windows Server 2008, and
Windows Server 2003
z The following steps are explained using Windows Server
2008 as an example. The steps and menus may differ
depending on the OS you use.
1 Click [Start] and select
[Administrative Tools]>[Server
Manager].
If [DHCP] is already shown in
[
Administrative Tools] continue to step 8.
2 Select [Add Roles] on the [Roles
Summary] area.
3 On the [Add Roles Wizard], click
[Next].
4 Select [DHCP Server] and then click
[Next].
5 Follow the on-screen instructions and
configure the settings as necessary.
6 On the [Confirm Installation
Selection] screen, check the settings
and click [Install].
7 When the installation finishes, click
[Close].
8 Click [Start] and select
[Administrative Tools]>[DHCP] to
launch the [DHCP] wizard.
9 On the DHCP list, select a server to use.
10 From the [Action] menu, select [New
Scope].
OK
OK
OK
OK
OK
OK
OK