Toshiba e-Studio 350

To Next Page

To Previous Page

ERROR CODE AND SELF-DIAGNOSTIC MODE

2 - 142

<<Procedure to copy the total counter value (08-257)>>

(1) Turn ON the power while [0] and [8] are pressed simultaneously.

(2) Key in the code “257” and press the [START] button (the following is displayed).

Note: Note:

Before performing the following operations, note the current counter values.

(3) Key in the value “1” or “2” and press the [START] button.

The value entered is displayed on the left of the “%”, and the [ENTER] button is displayed.

Note: Note:

The value can be erased by pressing the [CLEAR] button to change as long as the [START] but-

ton is not pressed. (The value on the left of the “%” is reset to “0” by pressing the [CLEAR] but-

ton.)

• Key in “1” to copy the value of the total

counter (LGC board) (A) onto the value of

the backup counter (SYS board) (B).

(A) (B)

05/12

Toshiba e-Studio 350 - Page 162