© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO350/352/353/450/452/453
ADJUSTMENT
3 - 7
3
3.2.3 Printer related adjustment
[A] Reproduction ratio of primary scanning direction (Fine adjustment of polygonal motor rota-
tion speed (Printer))
(1) While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(2) Press [1] → [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the lower
drawer.)
(3) Measure the distance A from the 1st line to the 21st line of the grid pattern.
(4) Check if the distance A is within 200±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance A again.
<Procedure>
(Adjustment Mode) → (Key in code [401]) → [START]
→ (Key in a value (acceptable values: 0 to 255))
→ [ENTER] or [INTERRUPT] (Stored in memory)
→ "100% A" is displayed.
→ Press [1] → [FAX] → (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance A becomes. (approx. 0.125 mm/
step)
[B] Primary scanning data laser writing start position (Printer)
(1) While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(2) Press [1] → [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the lower
drawer.)
(3) Measure the distance B from the left edge of the paper to the 6th line of the grid pattern.
(4) Check if the distance B is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance B again.
<Procedure>
(Adjustment Mode) → (Key in the code [411]) → [START]
→ (Key in a value (acceptable values: 0 to 255))
→ [ENTER] or [INTERRUPT] (Stored in memory).
→ "100% A" is displayed
→ Press [1] → [FAX] → (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance B becomes. (approx. 0.05 mm/
step)
(6) After the adjustment for the code 411 is completed, apply the same adjustment value for the
code 410.
<Procedure>
(Adjustment Mode) → (Key in the code [410]) → [START]
→ (Key in the same value in the step 5 above)
→ Press [ENTER] or [INTERRUPT] (Stored in memory).
Note: Note:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
04/09
To Next Page
Loading...
