e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 18
[F] Top margin
(1) While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(2) Open the platen cover or RADF.
(3) Press [FAX] to make a copy at the mode of A3/LD, 100%, Text/Photo and lower drawer.
(4) Measure the blank area E at the leading edge of the copied image.
(5) Check if the blank area E is within the range of 3 ± 0.5 mm.
(6) If not, use the following procedure to change values and repeat the steps 3. to 5. above.
<Procedure>
(Adjustment Mode) → (Key in the code [430]) → [START]
→ (Key in a value (acceptable values: 0 to 255))
→ Press the [ENTER] or the [INTERRUPT] button (stored in memory).
→ (“100% A” is displayed.)
* The larger the adjustment value is, the wider the blank area becomes (approx.0.04 mm/step).
Fig. 3-10
E
Feeding direction
04/05
To Next Page
Loading...
