e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
POWER SUPPLY UNIT
7 - 2
The followings are two output channels which are linked with the door switch.
1) +5.1V
+5.1VD: CN414 Pin 9
Output to the LGC board
2) +24V
+24VD1: CN414 Pins 1 and 2
Output to the LGC board, PFP/LCF (via LGC board)
+24VD1: CN418 Pin 1
Output to the power supply cooling fan
+24VD2: CN414 Pins 5 and 6
Output to the LGC board, Bridge unit / Job separator / Offset tray (via LGC
board)
+24VD3: CN415 Pins 1 and 2
Output to the RADF
+24VD4: CN415 Pins 9 and 10
Output to the SLG board
+24VD5: CN416 Pin 3
Output to the finisher
<Output connector>
1) Not linked with the door switch
CN412 For the SYS board
CN413 For the LGC board, FIL board / FUS board, FAX board (e-STUDIO350/450 only),
PFP/LCF (via LGC board), Bridge unit / Job separator / Offset tray (via LGC
board)
CN415 For the SLG board, RADF
CN416 For the finisher
2) Linked with the door switch
CN414 For the LGC board, PFP/LCF (via LGC board), Bridge unit / Job separator / Off-
set tray (via LGC board)
CN415 For the SLG board, RADF
CN416 For the finisher
CN418 For the power supply cooling fan
05/11
To Next Page
Loading...
