Printing Guide — Printing from Macintosh 281
• Short Edge Punch without rotation — Select this to create holes on the top for the por-
trait document, or on the right for the landscape document.
• Long Edge Punch with 180 degree rotation — Select this to create holes on the right
side for the portrait document, or on the bottom for the landscape document.
• Short Edge Punch with 180 degree rotation — Select this to create holes on the bot-
tom for the portrait document, or on the left for the landscape document.
NOTE:
• This option cannot be selected if a hole punch unit is not installed.
3) Stapling
This sets whether a print job is stapled.
• Off — Select this to print without stapling.
• Upper Left (Portrait)/Upper Right (Landscape) — Select this to staple in the upper
left for the portrait document, or in the upper right for the landscape document.
• Middle Left (Portrait)/Middle Top (Landscape) — Select this to staple double in the
left for the portrait document, or in the top for the landscape document.
To Next Page
Loading...
