Page 11
Scan to File (Cont’d.)
5. Select the desired location.
y MFP LOCAL: Originals are stored in the e-STUDIO’s hard disc drive. The original
data will be stored under the directory path shown on the screen.
y REMOTE 1, REMOTE 2: Select when the originals should be stored in a network
file folder or the hard disc of the user’s PC via server. The network administrator must
define these settings prior to using REMOTE 1 or REMOTE 2.
TIP: You can select 2 locations to simultaneously store the data from MFP LOCAL,
REMOTE 1 and REMOTE 2.
6. Select the file format. The SCAN folder is
automatically created, and the original data will
be stored into this folder. If you select “TIFF
(SINGLE)”, an additional folder with the name
you entered above is further created, and each page
will be stored into this folder. You can access the
original data with the client PC via network, by
opening the FILE_SHARE folder in the equipment’s
hard disc.
7. Press the EDIT button, set the original type and the
scanning conditions, and press the ENTER button.
8. Press the Next or Prev button to switch the screen
and make necessary settings.
To Next Page
Loading...
