153
7
5. SETTING RX PRINTING
Setting RX Printing
Set print settings for originals received on the Fax that are to be printed.
2 print installations are available: discard printing and RX reduction printing.
- Discard Printing
ON (default setting):
When originals are up to 10 mm larger than the printing area; the part of the originals that extends beyond
the paper printing area is discarded.
OFF:
The received original is printed on 2 sheets of paper if its length exceeds the paper printing area.
* For the detail of DISCARD setting, contact your service technician.
- RX Reduction Printing
ON (default setting):
If the received original is longer than the recording paper, it will be vertically reduced to 90% to fit on the
installed receiving paper.
OFF:
The received original is printed on 2 sheets of paper if its length exceeds the paper printing area.
* Drawers can be set for received Fax printing only. See the [Operator’s Manual for Basic Function]. Be
sure to use LD, LG, LT, LT-R, A3, A4, A4-R or B4.
1
Press the [USER FUNCTIONS] button on
the control panel.
2
Press the [ADMIN] button to enter the
administrator password menu.
- See the [User Functions Guide] for the administrator password.
3
Press the [PASSWORD] button, enter the
administrator password, and then press
the [ENTER] button.
To Next Page
Loading...
