© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO350/352/353/450/452/453
SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
1 - 3
1
y Paper feeding ....................... Automatic feeding:
Standard drawers–2 drawers (stack height 60.5 mm, equivalent to 550
sheets; 64 to 80 g/m2 (17 to 22 lb.))
PFP–Option (One drawer or two: stack height 60.5 mm, equivalent to
550 sheets; 64 to 80 g/m2 (17 to 22 lb.))
LCF–Option (Stack height 137.5 mm x 2: equivalent to 2500 sheets; 64
to 80 g/m2 (17 to 22 lb.))
Bypass feeding:
(Stack height 11 mm: equivalent to 100 sheets; 64 to 80 g/m (17 to 22
lb.))
y Capacity of originals in the reversing automatic document feeder (Option)
.................................................. A3 to A5-R, LD to ST-R:
100 sheets / 80 g/m
2
(Stack height 16 mm or less)
y Automatic duplexing unit ...... Stackless, Switchback type
y Toner supply ......................... Automatic toner density detection/supply
Toner cartridge replacing method
y Density control...................... Automatic density mode and manual density mode selectable in 11
steps
y Weight .................................. 83 kg, 183 lb. (e-STUDIO350/450)
86 kg, 189.59 lb. (e-STUDIO352/353/452/453)
y Power requirements ............. AC 110 V (±10%) / 13.2 A, 115 V (±10%) or 127 V (±10%) / 12 A
220-240 V (±10%) or 240 V (±10%) / 8 A
y Power consumption.............. 1.5 kW or less (100 V series), 17 kW or less (200 V series)
* The electric power is supplied to the RADF, Finisher, PFP and LCF through the equipment.
y Total counter......................... Electronical counter
y Dimensions of the equipment See the figure below
W660 x D718 x H739 mm (e-STUDIO350/450)
W660 x D758 x H739 mm (e-STUDIO352/353/452/453)
y When the tilt angle of the control panel is 45 degrees.
Fig. 1-1
45˚
W
D
H
07/11
To Next Page
Loading...
