© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO350/352/353/450/452/453
SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
1 - 7
1
Notes:
1. The bridge kit (KN-3520) is necessary for installation of the finisher (MJ-1022, MJ-1023/1024
or MJ-1101).
2. The finisher (MJ-1023/1024) is necessary for installation of the hole punch unit (MJ-6004N/E/
F/S). The finisher (MJ-1101) is necessary for installation of the hole punch unit (MJ-6101N/E/
F/S).
3. The PCI slot (GO-1060) is necessary for the installation of the scrambler board (GP-1040).
4. The antenna (GN-3010) is necessary to enable the wireless LAN module (GN-1041) and
Bluetooth module (GN-2010).
5. When the wireless LAN module (GN-1041) and the Bluetooth module (GN-2010) are
installed, only 1 antenna (GN-3010) can be connected to each.
6. The Printer kit (GM-1060) or Printer/Scanner kit (GM-2060) does not have a function for print-
ing an XPS file.
7. To enable an XPS file to be printed by the Printer kit (GM-1061) or Printer/Scanner kit (GM-
2061), the Memory (GC-1230) is required to be installed.
8. To enable an XPS file to be printed by the Printer ELK (GM-1120) or Printer/Scanner ELK
(GM-2120), the Memory (GC-1230) is required to be installed.
07/11
To Next Page
Loading...
