Toshiba e-STUDIO 450 - Controlling the Use of the Copier with Department Codes

32
1.BEFORE USING EQUIPMENT
2.TURNING ON THE POWER SWITCH (Cont.)
1
Controlling the Use of the Copier with Department Codes
With the use of the department codes, you can restrict users as well as manage copy volumes made by
individual groups or departments of your company. See the [User Functions Guide].
1
When the department management
function is in use, the screen shown on
the right appears immediately after the
power switch is turned on.
- The same screen is displayed when the [ACCESS] button is
pressed or the automatic function clear mode is activated.
2
Key in a registered department code (5-
digit).
- The copier will be ready for copying.
If “Enter Department Code” remains, the department code you have
entered may be incorrect. Press the [RESET] button, and then key
in the correct code.
- After Copying is finished.
If the department control function is in use, be sure to press the
[ACCESS] button on the control panel after finishing the use of
the equipment. The display returns to the department code input
screen and the department management function will remain
active.