Toshiba e-STUDIO163 - Disassembly and Replacement

e-STUDIO163/203 © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
10 - 10
10.5 Disassembly and Replacement
[A] Bypass unit
(1) Take off the ADU cover.
" P.2-21 "[G] ADU cover"
(2) Remove 1 screw and take off the harness
cover.
Fig. 10-6
(3) Release the harness from the harness clamp
and disconnect 1 connectors.
Fig. 10-7
(4) Remove 2 screws, and take off the bypass
unit by lifting it up.
Note:
When installing the bypass unit, place the
guide behind the transfer unit.
Fig. 10-8
Screw
Harness cover
Connector
Bypass unitScrew
Screw
Guide