e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 24
[B] SRAM board (SRAM)
[C] Fuse PC board (FUS)
Note:
This fuse PC board is copacked with the damp heater unit. (The damp heater unit is optional for
NAD, CND and MJD.)
(1) Take off the rear cover.
" P.2-22 "[J] Rear cover"
(2) Release 1 lock support and take off the
SRAM board.
Notes:
1. Be sure to perform “08-388” after the
SRAM board has been replaced.
2. Perform "05-310" with the platen cover
and the ADF closed after replacing the
SRAM board.
3. Make sure that the direction of the battery
on the SRAM board is correct when
replacing it.
Fig. 2-25
Fig. 2-26
(1) Take off the rear cover.
" P.2-22 "[J] Rear cover"
(2) Remove 2 screws and take off the cover.
Fig. 2-27
SRAM board
SRAM board
Battery
Cover
To Next Page
Loading...
