e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 8
(D) Replace the toner cartridge
(E) Developer unit not installed properly
(F) Call for service
Error code is displayed instead of the set number by pressing the [CLEAR] button and [8] button
simultaneously when the service call lamp is blinking.
Refer to the error code table in the Service Handbook.
• The PFU paper feed sensor is not turned ON in a fixed period of time after the pickup solenoid is
turned ON
#
Paper jam (E14)
• Toner density becomes low
#
Auto-toner sensor detects the absence of the toner
#
Control circuit % The toner lamp brinks: the copying operation disabled
Solution: Open the front cover and replace the toner cartridge with a new one.
Toner is supplied % copying operation enabled.
• Disconnection of the connectors of the developer unit
#
The equipment enters the following state:
The toner lamp brinks, the start lamp is turned OFF and all buttons disabled.
#
Solution: Connect the connectors of the developer unit and close the front cover.
To Next Page
Loading...
