e-STUDIO163/166/203/206 © 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 56
900 Version System firmware ROM ver-
sion
ALL - - e-STUDI0163/203:
T280SY0W0xx
e-STUDIO166/206:
T280SY0W1xx
Displays only the last
three digits.
2
921 Version FROM internal program ALL - - VTGxx.xxxW
Displays the “xx.xxx”
part of the above code
as “xx-xxx”. (Press the
reproduction ratio but-
tons to switch the dis-
play between “xx-”and
“xxx”.)
2
949 General Automatic interruption
page setting during printing
ALL 0
<0-100>
SYS Sets the automatic
interruption page.
1
970 User
interface
Sound setting when
switching to Energy Saving
Mode
ALL JPN: 0
Other: 1
<0-1>
SYS 0: OFF
1: ON
1
971 General Toner near empty thresh-
old value
ALL e-
STUDIO
163/203:
JPN: 1
CND: 3
Other: 1
<0-3>
e-
STUDIO
166/206:
1
<0-3>
SYS Performs adjustment
for the toner near-
empty detection timing.
0: Toner near empty
threshold value
(long)
1: Toner near empty
threshold value
(standard)
2: Toner near empty
threshold value
(short)
3: Toner near-empty
detection disabled
This code is automati-
cally changed to “3”
when the code 08-695
has been set at “0”.
This code is automati-
cally changed to “1”
when the code 08-695
has been set at “1” or
“2.”
1
975 General Job handling when print-
ing is short paid with coin
controller
ALL 1
<0-1>
M Sets whether printing is
to be paused or
stopped when the pre-
paid balance runs out
during printing.
0: Pause printing and
wait for additional
payment.
1: Stop printing and
cancel the accepted
print job.
1
Setting mode (08)
Code
Classifi-
cation
Items
Func-
tion
Default
<Accept-
able
value>
RAM Contents
Proce-
dure
06/05
To Next Page
Loading...
