Toshiba e-studio182 - Page 203

11
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO182/212/242
DEVELOPMENT SYSTEM
11 - 19
(6) Take off the mixers-2 and -3.
Fig. 11-32
(7) Remove 2 bushings and 2 oil seals on the
rear side.
(Replacement of Oil seal:  P.11-20 "11.6.8
Replacement of Oil Seal")
Fig. 11-33
(8) Remove the end section of the mixer-1.
(9) Remove the bushing and oil seal.
(Replacement of Oil seal:  P.11-20 "11.6.8
Replacement of Oil Seal")
Fig. 11-34
(10) Take off the mixer-1.
Fig. 11-35
Mixer-3
Mixer-2
Oil seal
Bushing
Oil sealBushing
End section of mixer-1
Mixer-1