Toshiba E-STUDIO2006 - Page 531

05/08 Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptabl
e value
SRAM Contents
Proce
dure
20L
/
23L /
25L
20H
/
23H /
25H
05 Adjustment
mode
Printer Image FAX Reproduction
ratio in the
secondary
scanning
direction (For
FAX
resolutions in
millimeters)
4010 - Fine adjustment of the
rotational speed of the
main motor
128 0-255 M When the value increases by "1", the reproduction ratio
of secondary scanning direction increases by approx.
0.14mm/step.
1
-Y
05 Adjustment
mode
Printer Image PPC/PRT For
resolutions in
inch
4013 - Fine adjustment of the
rotational speed of the
exit motor
128 0-255 M 1
YY
05 Adjustment
mode
Printer Image FAX For FAX
resolutions in
millimeters
4014 - Fine adjustment of the
rotational speed of the
exit motor
128 0-255 M 1
-Y
05 Adjustment
mode
Printer Image Adjustment of
drawer sideways
deviation
4018 0 Upper drawer 128 0-255 M When the value increases by "1", the image shifts toward
the front side by 0.0423 mm.
4
YY
05 Adjustment
mode
Printer Image Adjustment of
drawer sideways
deviation
4018 1 Lower drawer (PFU) 128 0-255 M When the value increases by "1", the image shifts toward
the front side by 0.0423 mm.
4
YY
05 Adjustment
mode
Printer Image Adjustment of
drawer sideways
deviation
4018 2 PFP upper drawer 128 0-255 M When the value increases by "1", the image shifts toward
the front side by 0.0423 mm.
4
-Y
05 Adjustment
mode
Printer Image Adjustment of
drawer sideways
deviation
4018 3 PFP lower drawer 128 0-255 M When the value increases by "1", the image shifts toward
the front side by 0.0423 mm.
4
-Y
05 Adjustment
mode
Printer Image Adjustment of
drawer sideways
deviation
4018 5 Bypass feeding 128 0-255 M When the value increases by "1", the image shifts toward
the front side by 0.0423 mm.
4
YY
05 Adjustment
mode
Printer Image Adj. of primary scan.
writing start
Duplex
feeding
4019 0 Long size 148 0-255 M If the value increases, the dimension B becomes
longer.(about 0.5mm/10 steps)
4
YY
05 Adjustment
mode
Printer Image Adj. of primary scan.
writing start
Duplex
feeding
4019 1 Short size 148 0-255 M If the value increases, the dimension B becomes
longer.(about 0.5mm/10 steps)
4
YY
05 Adjustment
mode
Printer Image Margin adjustment PPC 4050 - Top margin 60 0-255 M When the value increases by "1", the blank area becomes
wider by approx. 0.042 mm.
1
YY
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
14-1-11
e-STUDIO2006/2306/2506/2007/2307/2507
SELF-DIAGNOSIS CODE (03/04/05/08 CODE)