e-STUDIO182/212/242 © 2009 TOSHIBA TEC CORPORATION All rights reserved
DEVELOPMENT SYSTEM
11 - 12
11.6.2 Developer material
Notes:
1. When installing the process unit, make
sure that the connector (harness) is not
caught under the developer unit.
2. When closing the drawer of the
equipment, make sure that the connector
(harness) is not caught.
3. Make sure that the harness on the upper
part of the process unit does not contact
the frame of the equipment.
Fig. 11-8
Fig. 11-9
(1) Take out the developer unit
P.11-11 "11.6.1 Developer unit".
(2) Remove 2 screws and slide the developer
unit upper cover to the direction of the arrow
and take it off.
Fig. 11-10
Developer unit upper cover
To Next Page
Loading...
