e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING June 2004 © TOSHIBA TEC
5 - 64
[Procedure 3]
Does the tray go up?
l
l
l
l
l
l
l
l
l
l
l
l
#
YES
NO Is 24 VDC supplied from the finisher controller PCB to the shift motor as
soon as the tray is driven?
#
NO Replace the finisher controller PC board.
YES
Is there any problem with the tray up/down mechanism?
#
YES Fix the lift mechanism.
NO
Replace the shift motor.
Is the shift motor clock sensor (PI7) working properly?
#
YES Replace the finisher controller PC boar
NO
Replace the sensor.
[CB50] Staple motor abnormality
MJ-1025
[Procedure 1]
Is the wiring between the finisher controller PC board and the staple/fold motor normal?
#
NO Correct the wiring.
YES
Try to rotate the staple jam releasing dial. Is there mechanical trapping?
#
YES Fix the mechanism.
NO
Try replacing the staple/fold motor (M7). Is the problem corrected?
#
YES End.
NO
Replace the finisher controller PC board.
To Next Page
Loading...
