June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5 - 65
5
[Procedure 2]
Is the staple/fold motor clock sensor (PI14) working properly?
#
NO Replace the sensor.
YES
Does the staple/fold motor operate at the appropriate timing?
#
YES Replace the finisher controller PC board.
NO
Is the stapler unit drive mechanism working properly?
#
NO Fix the mechanism.
YES
Try replacing the staple/fold motor (M7). Is the problem corrected?
#
YES End.
NO
Replace the finisher controller PC board.
[Procedure 3]
Is the folding home position sensor (PI11) working properly?
#
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the staple/fold motor normal?
#
NO Correct the wiring.
YES
Try to rotate the fold jam releasing dial. Is there mechanical trapping?
#
YES Fix the mechanism.
NO
Try replacing the staple/fold motor (M7). Is the problem corrected?
#
YES End.
NO
Replace the finisher controller PC board.
To Next Page
Loading...
