2 COPY FUNCTIONS
38 Basic Copy Procedure
If originals remain on the Reversing Automatic Document Feeder after pressing [FINISHED] on the
CONTINUE SCAN screen, remove all the originals. Leaving them may cause a paper jam.
When the copying has finished, press [FUNCTION CLEAR] to clear the set copy functions and return to
the main screen (Copy).
If the paper source runs out of paper, an error message is displayed on the LCD screen and copying
stops. Load paper. The equipment automatically resumes copying after approx. 3 seconds have
passed.
The receiving tray can hold up to 100 sheets. If the excessive paper error occurs, the lamp blinks and
an error message is displayed on the LCD screen. Remove the paper from the tray and press [START]
to resume copying.
When you use overhead transparencies, remove them one by one every time they are ejected.
Otherwise, they could be curled and not be good for projection.
To Next Page
Loading...
