6
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
SCANNER
6 - 23
(4) Move the carriage-1 to the cutout part. Pull
down each bracket fixing the wire from the
hole of the frame on both ends of the car-
riage-1.
Fig. 6-35
Note:
Rotate the drive pulley to move the carriage.
Fig. 6-36
(5) Disconnect 1 connector from the SLG board.
Remove 2 seals and release the lamp har-
ness.
Fig. 6-37
Bracket
Drive pulley
Seal
07/03
To Next Page
Loading...
