11
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
DRUM RELATED SECTION
11 - 17
[O] Transfer unit
Note:
When taking off the transfer unit, take off the process unit first to prevent the drum from light.
(1) If the ADU is not installed, take off the right
front hinge cover, the right rear hinge cover
and the bypass upper cover ( P.2-38 "[P]
Right front hinge cover", P.2-39 "[Q] Right
rear hinge cover", P.2-39 "[R] Bypass
upper cover").
If the ADU is installed, take off the ADU
( P.15-10 "[A] Automatic Duplexing Unit
(ADU)").
(2) Take off the bypass unit
( P.9-17 "[G] Bypass unit").
(3) Release 1 latch and take off the transport
guide.
Fig. 11-29
(4) Open the transfer unit and disconnect 5 con-
nectors.
Note:
When installing the unit, do not connect the
connectors in the wrong places.
Fig. 11-30
(5) Slide the transfer unit to the rear side to dis-
place the supporting point on the front side.
Then take off the transfer unit.
Fig. 11-31
Latch
Transport guide
ConnectorConnector
(
White
)
Connector
(
Yellow
)
Transfer unit
To Next Page
Loading...
