e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
AUTOMATIC DUPLEXING UNIT (ADU) (OPTION: MD-0102)
15 - 16
[I] Middle transport roller
(1) Take off the ADU drive unit
( P.15-13 "[G] ADU motor / ADU drive
unit").
Fig. 15-27
(2) Remove 2 clips, 2 pulleys and 2 pins on the
front side. Then take off the timing belt.
Fig. 15-28
(3) Remove 1 E-ring and 1 clip on the rear side.
(4) Take off 2 bushings and middle transport
roller.
Fig. 15-29
ADU drive unit
Pin
Pin
Timing belt
Pulley
Clip
Middle transport roller
Clip Bushing
Bushing
E-ring
To Next Page
Loading...
