Toshiba e-STUDIO233 - Page 79

2
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
OUTLINE OF THE MACHINE
2 - 45
[C] System control PC board (SYS board)
[C-1] e-STUDIO200L/230/230L/280/280S
[C-2] e-STUDIO202L/203L/232/233/232S/282/283/282S/283S
(1) Take off the SYS board upper cover and SYS
board lower cover ( P.2-41 "[A] Hard disk
(HDD)").
(2) Take off the NIC board
( P.2-44 "[B] NIC board (GF-1150)").
(3) Disconnect 4 connectors, remove 8 screws,
and then take off the SYS board.
Fig. 2-55
(1) Take off the SYS board cover ( P.2-41 "[A]
Hard disk (HDD)").
(2) Disconnect 4 connectors, remove 8 screws,
and then take off the SYS board.
Fig. 2-56
SYS board
Screw
Screw
Screw
SYS board
07/11