e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 46
[D] SYS board case
[D-1] e-STUDIO200L/230/230L/280/280S
(1) Take off the SYS board upper cover and SYS
board lower cover
( P.2-41 "[A] Hard disk (HDD)").
(2) Disconnect 4 connectors and release the
harness from 3 harness clamps.
Fig. 2-57
(3) Remove 5 screws and take off the SYS
board case.
Fig. 2-58
Harness clamp
Harness clamp
SYS board case
Screw
Screw
05/11
To Next Page
Loading...
