e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 110
Erase some data in the Electronic Filing and perform the job in error again (in case of [2B30]).
Ask the administrator if e-Filing has been disabled. (In case of [2CC1])
Turn the power OFF and then back ON. Perform the job in error again.
Check if there are no other running jobs and perform the HDD formatting (08-690).
If the recovery is still not completed, replace the SYS board.
[2B50] Image library error
[2B90] Insufficient memory capacity
Turn the power OFF and then back ON. Perform the job in error again.
If the error still occurs, replace the main memory.
Perform the job in error again.
Check if there are no other running jobs and initialize the Electronic Filing using the Setting Mode
(08-666).
[2B31] Status of specified Electronic Filing or folder is undefined or being created/deleted
Check if the specified Electronic Filing or folder exists. (If no, this error would not occur.)
Delete the specified Electronic Filing or folder.
Perform the job in error again.
If the specified Electronic Filing or folder can not be deleted, initialize the Electronic Filing using the
Setting Mode (08-666).
[2B32] Electronic Filing printing failure: Specified document can not be printed because of
client's access (being edited, etc.)
Check if the specified document exists. (If no, this error would not occur.)
Delete the specified document.
Perform the job in error again.
If the specified document can not be deleted, initialize the Electronic Filing using the Setting Mode
(08-666).
[2B51] List library error
Check if the Function List can be printed out.
If it can be printed out, perform the job in error again.
If it can not be printed out, replace the main memory.
If the recovery is still not completed, perform the HDD formatting (08-690).
[2BA0] Invalid Box password
Check if the password is correct.
Reset the password.
When this error occurs when printing the data in the Electronic Filing, perform the printing with the
administrator's password.
If the recovery is still not completed or in case of invalid password for the operation other than
printing (opening the file, etc.), initialize the Electronic Filing using the Setting Mode (08-666).
[2BA1] A paper size or a color mode not supported in the Electronic Filing function is being
selected.
Check the paper size or color mode.
[2BB1] Power failure
[2BD0] Power failure occurred during restoring of Electronic Filing
To Next Page
Loading...
Need help?
General
