2.INSTALLING DRIVERS
Installing Drivers 17
2 INSTALLING DRIVERS
Installing the drivers using Plug and Play
Before installing the drivers, connect the equipment and your Windows computer with a USB cable. When using Plug and
Play, first the scanner driver is installed, and then the printer driver.
An additional printer wizard can also be used to install the printer driver. To use the additional printer wizard, select the
USB port or the network port that the equipment is connected to using “Choose a Printer Port”.
Installing the drivers on Windows Vista / Windows Server 2008
1
Connect this equipment to the computer using a USB cable, and then start the
computer.
Do not connect or disconnect the USB cable when starting up the computer.
2
Turn on the equipment.
The Found New Hardware dialog box appears.
If it does not appear, turn off this equipment, and then wait approximately 10 seconds before turning it on again. If
you turn this equipment on immediately after turning it off, it may not function correctly.
3
Click “Locate and install driver software (recommended)”.
The dialog box requesting the disk (Client Utilities/User Documentation DVD) appears.
If the User Account Control dialog box appears, click [Allow] or [Continue].
To Next Page
Loading...
